FREE Shipping on all orders over $99 & LIMITED TIME USE CODE "NEW" FOR 10% OFF

Fire Sensor

Fire Sensor

Regular price
$17.99
Regular price
$25.99
Sale price
$17.99
Unit price
per 
Availability
Sold out

This is a kit to make your very own wifi openhab mqtt fire sensor. This fire sensor will tap into your pre-existing fire detectors and will send a MQTT message to the OpenHAB so you can tell if it went off. When I make the videos for this sensor we will also set it up that if this device goes off then you will get a notification on your mobile device, if you have openHAB cloud connector setup. This fire sensor will only work if you have a fire detector with interconnect functionality. An interconnected fire detector is usually one that is hardwired and runs off of mains power. This device will connect to the RED and WHITE wires of the fire detector.

Both the DIY Kit and Assembled device come with MK-FireSensor firmware version 2 installed so all you have to do is connect it to your server using your mobile phone.

Included in this kit:

2 pin Terminal

x2

4 Pin Female Header

x1

3 Pin Male Header

x1

2 pin Jumper

x1

5v to 3.3v Regulator

x1

PC817 Optocoupler

x1

10K Resistor

x1

330 Ohm Resistor

x1

1K Resistor

x1

Esp8266

x1

PCB

x1

Plastic Enclosure

x1

2 Conductor 22 Gauge Cable

x2

Male USB Connector

x1

Screws

x2

Wall Tac

x1

WHITE Heat shrink

x1

Please also note: If you would like this kit put together for you, so all you have to do is plug it in and connect it to your OpenHAB or Home Assistant server then click the Assembled option in the dropdown.